223
Polycab
Procedure:
1. Insert the RJ45 connector into the first inverter‘s COM3 socket.
2. Insert the other end of the cable into the COM2 socket on second inverter.
3. Connect the other inverters to each other in the same way.
4. Terminate the last inverter according to the inverter manufacturer‘s instructions.
Assign the communication address
•
Recommendation: Continuous numbering starting with 1.
•
Default settings on the inverter: Communication address 1.
•
Setting: Using the inverter‘s operating display.
•
Procedure: Start according to the inverter manufacturer‘s instructions.
To Next Page
Loading...