© Stäubli 2009 – D28070504A CS8C100 / 248
Downloading a PLC program
PLC programs are downloaded from the PLC development environment:
• Log on to the CS8C controller (IP address, TCP port)
• Click on the download button
The progam is then sent to the controller and it starts immediately.
If a PLC program is already being executed, it may be necessary to stop it via the programming environment
before downloading the new program.
The download also copies the PLC program on the CS8C, which means that the last program downloaded is
executed automatically when the controller is started up.
Archiving the PLC program
The source files are necessary to log on to the controller again and take over control of the PLC.
CAUTION:
The source files of the PLC program must be archived with care.
The CS8C controller contains only a binary format that does not enable the source files to be
found.
To Next Page
Loading...
Need help?
General