DOC-06810 Rev. A 6–5
Objet1000 Plus User Guide
Tips about loading and replacing material containers:
¾ You can load partially used containers, as long as they contain more than
100 grams of material.
¾ You can replace material containers either before or during printing.
¾ If printing stops for an extended time before you replace a material
container, the printer may go into Standby or Idle mode. If this happens,
see “Resuming Production After Printing has Stopped” on page 10.
¾ You can replace partially used containers to avoid the need for replacing
them during printing.
¾ The container type is automatically detected by the printer. If you replace
a container containing different Model material, a message appears
recommending that you run the Material Replacement wizard to flush out
the old material.
To Next Page