Operating & Maintaining the Objet1000 Plus 3D Printer
6–2
DOC-06810 Rev. A
Figure 6-1: The Objet1000 Plus 3D Printer
Starting the Objet1000 Plus Printer
1. Turnonthemainpowerswitch,locatedatthebackoftheprinter.
Figure 6-2: Main power switch
Turningontheprinteralsoturnsonthetwobuilt‐incomputers.
CAUTION!
¾
Do not attempt to operate the Objet printer before being trained by a
Stratasys customer-support representative.
¾ Observe all safety warnings and follow the safety guidelines described
in chapter 2.
To Next Page
Loading...
