Operating & Maintaining the Objet1000 Plus 3D Printer
6–10
DOC-06810 Rev. A
Resuming Production After Printing has Stopped
Iftheprintingprocessisinterrupted,ObjetStudiostopssendingslicesto
theprinter.Thiscanhappen,forexample,iftheprintingmaterialrunsout
inthemiddleofaprintjob,andyoudon’treplacetheemptycontainer
immediately.Aftertheprinterchangesto StandbyorIdlemode,youneed
to
resumeprintingfromtheJobManagerscreenofObjetStudio.
To continue printing the model:
1. Iftheprinterisinofflinemode,switchittoonlinemodebyclickingthe
redbuttonatthebottomoftheprinter interface(seefigure 6‐3on
page 3).
Thebuttonchangesfromredtogreen(seefigure 6‐5onpage 7).
2. Ifyoudon’tknowwhyprintinghasstopped,makesurethatthe
connectionbetweentheprinterandtheservercomputerisactive.
3. IntheJobManagerscreenofObjetStudio,clicktheResumeicon .
4. IntheContinuefromSlicedialogboxthatappears,confirmtheslice
number,aftercheckingtheprinterinterface.
5. IntheResumefromSlicedialogboxthatappears,makesure
thatthe
correctslicenumberisentered,aftercheckingtheprinterinterface.
Figure 6-7: Printer interface after interrupted printing
Figure 6-8: Continue from Slice confirmation in Objet Studio (Job Manager
screen)
6. If,foranyreason,thecorrectnumberdoesnotappearinthedialog
box,enterthenumberandclick
OK.
After printing stops, the printer goes into Standby mode, when heating of
print heads is reduced. About 10 hours later, the printer goes into Idle mode,
when heating of print heads is stopped.
Printer mode
Last slice printed
To Next Page