Stratasys Objet260 Connex - Replacing the Waste Containers

DOC-06810 Rev. A 6–75
Objet1000 Plus User Guide
Replacing the
Waste
Containers
Printerwastecontainspartiallycuredpolymericmaterial,collectedduring
normaloperationandmaintenanceoftheprinter.Forsafetyand
environmentalreasons,thismaterialiskeptintwoleak‐proofcontainers.
Eachcontainerhasacapacityof18kilogramsofwastematerial.Theprinter
applicationdisplaysawarningmessagewhenonewaste
containerisfull
andthereare17kilogramsofmaterialintheothercontainer.(Ifonlyone
wastecontainerisinstalled,themessageappearswhenthereare17
kilogramsofmaterialinit.)Theprinterstopsprintingwhenthenetweight
inthesecond(oronly)containerreaches17.5kilograms.When
thenet
weightinthiscontainerisabove17kilograms,thesoftwaredoesnotallow
youtostartaprintjob(oraprintingactivity)untilyoureplace(orinstall)a
wastecontainer.Youcanmonitortheweightofthewastecontainersinthe
printerinterface.
Cleaning the
Exterior Panels
ThepaintedexteriorplasticpanelsofObjet3Dprintershaveadurable
finish,offeringexcellentchemicalresistancetocommoncleaningmaterials.
Followtherecommendationsbelowwhencleaningtheseareasofthe
printer.
AcceptableCleaningAgents
• mildsoapsolution
• commonhouseholdcleanersandwindowcleaners
• commoncommercialandindustrialdetergents,5%solutioninwater
• alcohol(ethanol,isopropanol),10%to40%solutioninwater
Wipetheexterioroftheprinter,usingasoftclothmoistenedwiththe
cleaningsolution.
UnacceptableMaterials
•
industrialsolvents
• cleaningagentscontaininghydrocarbons,ketones,estersandlacquer
thinners
• spraydisinfectants
• abrasivesandagentswhichcouldwearawaythepanelfinish
CAUTION: Dispose of full waste containers in accordance with
environmental and safety requirements.
Empty Model-material and Support-material containers can be used as
printer-waste containers.