Stratasys Objet260 Connex - Routine Maintenance Schedule

Operating & Maintaining the Objet1000 Plus 3D Printer
6–20 DOC-06810 Rev. A
Maintaining the Printer
Theperformanceofroutinemaintenancetasksisessentialforgetting
satisfactoryresultsfromObjet3Dprinters.Performthetasksatspecified
intervalsforoptimumperformance.
Routine
Maintenance
Schedule

Frequency Task For More Information
Before/afterprinting Ch eck UVlamp
overheatingindicator.
See“UVLampCheck”
onpage 21.
Before/afterprinting Routine cleaningof:
•printheads
•rollersurface
•wiper
•buildtrayand
surroundingarea
See“CleaningthePrint
Heads,Rollerand
Wiper”onpage 21.
Weekly Cleanthepurgeunit
wastecollector.
Seestep15of
“CleaningthePrint
Heads,Rollerand
Wiper”onpage 21.
Weekly PerformthePatterntest. See“PatternTest”on
page 25.
Weekly Cleantherollerwaste
collector.
See“CleaningtheRoller
WasteCollectorand

InspectingtheRoller
Scraper”onpage 27 .
Every300hoursof
printing(Areminder
messageappears.)
CalibratetheUV
intensity.
See“Testingand
CalibratingtheUV
Lamps”onpage 55.
Every300hoursof
printing
Optimizetheprint
heads.
See“Optimizing
(Calibrating)Print
Heads”onpage 36.
Every500hoursof
printing
Replacethewi per. Seestep16
of
“CleaningthePrint
Heads,Rollerand
Wiper”onpage 21.
Every700hoursof
printing
Replacetherollerpump
tubes.
See“Replacingthe
RollerWasteTube”on
page 58.
Monthly,andafter
replacingprintheads
Checkthealignmentof
theprintheads.
See“AligningthePrint
Heads”onpage 33.
Monthly Restarttheprinter
computerandthe
server computer.
Monthly Cleandebrisfromthe
Z‐axisshaftwitha
vacuumcleaner.