Stratasys Objet260 Connex - Page 149

DOC-06810 Rev. A 6–27
Objet1000 Plus User Guide
Cleaning the
Roller Waste
Collector and
Inspecting the
Roller Scraper
Therollerwastecollectorremoveswastematerialscrapedfromtheroller.
Suctionremovesthiswastetotheprinter’swastecontainer.
Thisassemblyshouldbecleanedweeklytopreventablockageinthetubes
leadingtothewastecontainer,sothatwastematerialdoesnotoverflow
intotheprinter.
To clean the roller waste collector:
1. Prepare—
• M2.5andM2Allen
®
keys
• disposablecleaninggloves
• isopropanol(IPA—isopropylalcohol)orethanol(ethylalcohol)
• cleaningcloth
• cottonswabs(Q‐tipsorsimilar)
2. Putonthegloves.
3. RemovetherightUV‐lampassembly:
a. DisconnecttheUVpowercableandthefanpowercable.
Figure 6-29: Disconnecting the right UV assembly
b. RemovethescrewthatsecurestherightUVlamp,andthenpulland
liftuptheUVlamp.
Fan power
connector
UV Power
connector
Screw