Stratasys Objet260 Connex - Page 133

DOC-06810 Rev. A 6–11
Objet1000 Plus User Guide
Youcannotcontinueprintingthemodelif:
• Thenumberofthelastsliceprinteddoesnotappearintheprinter
interface,eveniftheservercomputerdisplaystheContinuefromSlice
confirmationdialogbox.
• Therewasarelativelylonginterruptioninprinting,evenifthe“last
slice”and“continuefromslice”indicatorsarecorrect.Thepartofthe
modelalreadyprintedmaydeformorshrink,andtheremightbea
visibledifferencebetweenitandthenewlyprintedpart.Theeffectsofa
printingstoppage
onamodeldependonthemodelsizeandstructure,
Modelmaterialused,ambienttemperatureandthelengthofthe
stoppage.
If you cannot continue printing:
1. CanceltheprintjobintheJobManagerscreen.
2. Removethepartiallyprintedmodelfromthebuildtray.
3. RestartthejobfromtheJobManagerscreen(inObjetStudio).
You can stop and later resume printing from either the printer interface or
from the Job Manager screen of Objet Studio. After clicking the Stop button
on the printer interface, you can resume printing only from the Job Manager
screen. However, after clicking the Pause button in the printer interface, you
can only resume printing from the printer interface.