Stratasys Objet260 Connex - Page 192

Operating & Maintaining the Objet1000 Plus 3D Printer
6–70 DOC-06810 Rev. A
Test Interface TheBuiltInTestsscreenlistspre‐configuredtests,groupedbycomponent
categories.Inthisscreen,youselectandruntests,andtheresultsare
displayed.
Figure 6-114: Built In Tests screen
Test List TestName
Thiscolumnlistsallofthetests,togetherwithselectioncheckboxes.
Clickthecheckboxestoselectthetestsyouwanttorun.Toremovea
selection,clickthecheckboxagain.Toquicklyselectallofthetestsina
componentcategory,usetheGroupdrop‐downlistat
thebottomofthe
screen.
Group
Thiscolumnshowsthecomponentcategoriesforeachtest.
ThistellsyouwhichtestsarerunwhenselectingacategoryfromtheGroup
drop‐downlistatthebottomofthescreen.
Status
Thiscolumnshowstheresultsofeachtestafteryourunit:
Testsuccessfullycompleted.
Testfailed.
Unknownresults.(Thetesthasnotbeenrunyet.)