Stratasys Objet260 Connex - Page 45

DOC-06810 Rev. A 5–7
Objet1000 Plus User Guide
Placingmodel
filesonthebuild
tray
.
Always.
Pre‐build/build
commands.
Modelsareon
thebuildtray.

Settingmodel
dimensions.
Amodelis
selected.
Cutting,
copying,pasting
anddeleting
models.
Amodelis
selected.
Moving,rotating
andresizing
models.
Amodelis
selected.
• Assigninga
materialtoa
modelor
shell.
• Separatinga
modelinto
shells.
Amodelis
selected.
Assigningmodel
finishand
settingsupport
strength/
“hollow.”
Amodelis
selected.
Settingamodel’s
unitofmeasure
(millimetersor
inches).
Amodelis
selected.
Group Purpose When
enabled
Tray
Settings
Ribbon
Model
Settings
Ribbon
To quickly identify an icon, move the cursor over it to display a tooltip. The
“Undo” and “Redo” tooltips change to reflect your last Objet Studio action.
After activating some of the ribbon commands (by clicking them), they remain
active until you click another button or until you press the Escape key.