OnAir 2000M2 Digital Mixing Console
5-2 Service Terminal SW V4.0 Date printed: 12.11.03
5.1 Connecting Cable
The terminal is connected to the 10-pin header connector (P13) labeled
“SERVICE TERMINAL” on the Controller Board. The connecting cable
is a straight 10-pin header to 9-pin D-type cable, where wire no. 10 is not
used at the D-type connector side; a ribbon cable works fine, provided that
its length does not exceed 2...3 m.
Almost any ASCII terminal capable of handling 38.4 kbaud will work; the
Windows95 “HyperTerminal” or “Procomm” have been tested.
P13
P13
12345
678910
5
9
1
6
D-type, f
solder side
Service terminal
Controller board 1.942.100
To Next Page
Loading...
