GTS Technical Manual
9. April 2021 Edition: V1.00/2021 6-40
Copyright © 2020, Diversey
ST.08.16 error codes overview - 2100_4000_5000_3500µicro_V1.40.fm
1010 Data safe read Error while reading the Data safe has been detected. All
the aggregates are turned OFF and machine drives on re-
duced speed.
Check Data safe and connections.
Aggregates are
turned OFF and ma-
chine drives on re-
duced speed
E1010
2020 No response from OCM There was no response from OCM when machine has
been switched ON.
Check the TASKI bus/Data safe wires and connections.
Update the firmware.
Blocked E2020
2021 Data safe time out writing During the writing from the OCM to the Data safe a time
out has occurred.
Check the TASKI bus/Data safe wires and connections.
Update the firmware.
Blocked E2021
2022 Data safe error writing During the writing from the OCM to the Data safe an error
has occurred.
Check the TASKI bus/Data safe wires and connections.
Update the firmware.
Blocked E2022
2023 Data safe time out reading During the reading from the Data safe a time out has oc-
curred.
Check the TASKI bus/Data safe wires and connections.
Update the firmware.
Blocked E2023
2024 Data safe error reading During the reading from the Data safe an error has oc-
curred.
Check the TASKI bus/Data safe wires and connections.
Update the firmware.
Blocked E2024
8014 (only BMS) Charger I time out Charging time for I phase (first phase) has been detected
as too long. The charging has been aborted.
Check charger, batteries, wires and connections.
Red LED for charger
is ON
Error codes Function Control Machine status Display
informa-
tion
Table 4: Error codes overview
To Next Page
Loading...
Need help?
General