TechnipFMC Sening MultiFlow - Page 123

Sening
®
is a registered trademark of FMC Technologies
129
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
9.3.1.4.6 Payment mode query
 The payment mode query is activated by parameter 3.1.4.5.6 and takes
place after the invoice print-out. The following selection is displayed here:
 The selection made by the
operator is saved in the internal
logbook together with the
discharge information and
appears in the print-out of the
detailed trip report (see chapter
11.3 "Detailed Report" / page
221). Information on the
payment is also included if the
tour data is saved on a chip
card.
9.3.1.4.6.1 Request receipt copy
 The request of the output of a receipt copy is activated using parameter
3.1.4.5.7 and takes place after a receipt has been printed. It is then
possible to create additional copies immediately after the original receipt
has been printed. This is useful, for instance, if not using carbon paper
and saves having to make a detour via option 3 of the print menu.
9.3.1.4.6.2 Status display of data transfer from EMIS to the office interface
 In OBC mode the data transferred from the MultiFlow to the EMIS can be
transmitted by the EMIS to the office interface (e.g. FTP server). This
may take place immediately after a delivery or after a manually started
data transfer from the print menu. The transfer of the data from the EMIS
via the GSM/GPRS interface takes some time. MultiFlow users are
informed about the current transfer status via a status screen which is
displayed during this phase. This display is shown until the MultiFlow
receives a signal from the EMIS that the transfer has finished. A
corresponding message is issued to the user when the transfer complete
signal has been sent and/or in the event of transfer problems. If you do
not require this status display after delivery, it can be deactivated using
parameter 3.1.4.5.8.1 In this case transfer complete and/or transfer
problems are displayed only as system messages in the MultiFlow start
screen.
 In the event that a discharge is to be started at a point in time on the
MultiFlow when the EMIS is not yet ready to operate, a “Wait” screen will
be displayed by the MultiFlow before the actual discharge pre-selection.
Whilst this display is on, try to synchronize the MultiFlow and the EMIS.
As soon as both items of apparatus are ready, there will be an automatic
P a ym en t mo de
Se le ct io n:
1 No p ay me nt
2 Ca sh p ay me nt
3 Ch eq ue
4 C re di t ca rd
5 Di re ct d eb it
UP Do wn ---