TechnipFMC Sening MultiFlow - Page 154

160
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
Example: Driver's name in the third driver register
Driver Register
Parameter
36 3
2
The following operators are defined in the factory settings:
Employee ID.
Password
Access Right
000001
- - -
Driver
999999
654321
Master
* Passwords are always 6-digit numbers.
9.3.6.2 Defining the Driver's Name
 If several drivers are to drive a vehicle, it may be more practicable to
issue a personnel number for each driver. It is then, for example, possible
to print the driver's name on the delivery receipt to obtain a clear
assignment of deliveries to the drivers.
 The number is limited to five drivers. You define the drivers in Menu 3.6.
A list of the currently entered drivers is displayed.
 In order to be able to make changes to the driver list, the personnel number
of the system manager (master) must be entered followed by the master
password.
 This prevents unauthorized persons from changing the driver list.
The personnel number 999999 and master password 654321 are
determined in the factory settings. This personnel number is defined
as the fifth driver with the name "Master".
Display of driver list
 To make changes to the
settings, a driver is selected
from the list of the five drivers
using <Enter>.
After selecting a driver, you
can re-issue the driver ID,
the driver's name and the
master code.
If zero is entered as the
master code, then the driver
has no master rights.
Dri ve r Li st
Se le ct io n: 36
1 C . An yo ne
2 Dr iv er
3 Dr iv er
4 Dr iv er
5 Ma st er
Up Do wn ---