TechnipFMC Sening MultiFlow - Page 153

Sening
®
is a registered trademark of FMC Technologies
159
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
No.
Name
Seal
K
Factory
Setting
Meaning
3.5.nn.7.3
4
Product group
Cal.
1
Determination of the compensation algorithm in
dependence of the product group:
1 Packed Goods
2 Crude Oil (API-Table 54A)
3 Refined Oil (API-Table 54B)
4 Special Product (API Table 54X)
for liquid gas & bitumen
5 Lube Oil (API-Table 54D)
6 Direct-Linear (Mixed Products)
for e.g. E5, E10 …
See chapter 9.10 "Product Registers (35nn..)" / page 166.
9.3.6 Driver List
No.
Name
Seal
K
Factory
Setting
Meaning
3.6
Driver list
3.6.1
Driver 1
M
Driver Register 1 (entry of the driver's ID and name
and of the master code)
3.6.2
Driver 2
M
Driver Register 2 (entry of the driver's ID and name
and of the master code)
3.6.3
Driver 3
M
Driver Register 3 (entry of the driver's ID and name
and of the master code)
3.6.3
Driver 4
M
Driver Register 4 (entry of the driver's ID and name
and of the master code)
3.6.5
Driver 5
M
Driver Register 5, factory definition of master, can be
changed.
9.3.6.1 Driver Register (36n..)
No.
Name
Seal
K
Factory
Setting
Meaning
3.6.n.1
Driver ID
M
3
Personnel number of the driver
3.6.n.2
Driver Name
M
3
Name of the user, can be printed on receipts.
3.6.n.3
Master code
M
3
If not set to "0", then master code for increased
access.
"36n" is the driver's register number, with "n" varying from 1 to 6. For
unequivocal identification of a parameter the driver's register number is
extended by the parameter number.
4
Parameter 3.5.nn.7.3: This parameter is included in all product definitions.
"nn" replaces the actual product register number (10 – 39).