TechnipFMC Sening MultiFlow - Page 169

Sening
®
is a registered trademark of FMC Technologies
175
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
Two different versions of the chip card are available:
Picture
on card
Part No.
CS-CC-64
CS-CC-512
Supplied
Until 01 / 2004
From 02 / 2004
Up to
version
3.20[3.23]
1 card for parameters
1 card for parameters
Version
3.30[3.30]
and higher
2 cards for parameters
1 card for parameters
9.12.1 Saving the Parameters
 Save the parameters in menu 4.5.2.
☺ After checking the access rights (master) a security query is displayed:
"Transfer data from MultiFlow to chip card?"
 The procedure can be cancelled with <F2> ("No") and the chip card
remains unchanged.
 Confirm with <F1> ("Yes").
 If the chip card has only been used for other purposes before, another
warning is given:
"Chip card error! Incorrect format. Continue?"
 The procedure can be cancelled with <F2> ("No") and the chip card
remains unchanged.
 Confirm with <F1> ("Yes").
☺ During the transfer which takes about 90 seconds, the following
information appears:
"Transfer running... Please wait"