12
Setting of time and date
2 Display the counter readings
6 Stock monitoring (optional)
12. Monitoring the load (optional)
The Load management can be found in the Main Menu under Item 6
(Menu 6). It contains the following information:
Remaining volume in the
chamber →
Remaining additive volume in
the storage container →
Trigger alarm on undercutting
Of the selected limit →
Echo of entered value →
The entry field “Product Load” signifies the current remaining
volume in the vehicle compartments.
After loading set the initial value for the product.
After each discharge the uncompensated discharge volume is
subtracted automatically.
The remaining Load of additive is displayed in the central display
section. The additive is intended for an additive pump controlled by
the MultiFlow.
After loading set the initial value for the additive.
After each discharge the uncompensated discharge volume of
the additive is subtracted automatically.
The field “Warning at:” enables you to define a minimum Load.
The additive Load is compared with the minimum volume before
each discharge.
If the level falls below the limit, a warning is displayed:
“WARNING! Additive Load almost completely
used!”
To Next Page