This alarm is given to prevent the system from running empty
which would involve a refilling procedure.
You can deactivate the alarm by setting the minimum volume to
zero.
13. Setting the clock
You will find the clock setting in the main menu under point 12
(Menu 12) which contains the following data:
The active entry field is set to “Hour”
Here you can adjust the
entry from summer to
winter time by entering
the correct time in
numerical value.
If you want to adjust
the minutes also,
press the <Enter>
key.
Now the “Minute” field
is active.
Adjust by entering the
correct numerical
value.
Confirm the entered values by pressing the <Print> key.
The date may only be adjusted by personnel with a “Master” ID.
The date is subject to W&M restrictions.
You quit the menu by pressing the <Stop> key.
14. Alarm messages
Any error occurring, e.g. during discharge, is displayed immediately.
You confirm that you have
taken notice by pressing
<F1> ('OK'). The device
then decides whether to
continue the discharge, or
to terminate discharge
and print a receipt.
Alarms (error messages) are recorded in the log book.
To Next Page
Loading...
