Exit Setup mode
Press the
(SETUP/EXIT) key
14.7.5
MultiFlow parameterization
•
Parameter 3.2.1. Printer selection : FX
•
Parameter 3.2.2. Interface : RS232
•
Parameter 3.2.3. Baud rate : 9600
•
Parameter 3.2.4. Parity : Even
•
Parameter 3.2.6.1. FDW protocol : no
•
Parameter 3.2.9. Data bits : 8 bit
14.8 Printer TM-U295 - Information on DC converter
DCV 75-24-24
In some vehicles using an Epson TM-U295 printer, a sudden voltage drop
(e.g. when starting the vehicle) can lead to a voluntary shut-down in order
to protect the printer hardware. Afterwards the printer needs to be
powered off and on again.
In order to circumvent this, it is recommended to use a DC converter:
DCV 75-24-24, Sening part no 7300006.
To Next Page
Loading...
