•
Monitoring product and additive load
•
Automatic interruption of discharge when no flow is detected (timeout)
•
Trip reports on chip cards, digital office link
•
Support for a second currency, e.g. the EURO
•
TMC communication, tour planning on the basis of the TDL
specification
•
Maintenance of password secrecy, particularly of seal passwords
•
Storage of service personnel identifier in the electronic calibration seal
•
Printer control of the DR-295-FDW, paper ejection in any direction
•
Form control, print form elements depending on actual seal status
•
Form control, new form elements (“Totaliser Block 2”, “Calibration
remark”)
•
Parameter check with error report
•
Expanded update function
14.9.2
Version 2.20
•
Introduction of a new printer (DR-298)
•
Adaptations to the GVLx_xM valve grouping for flow control
•
Display and evaluation of the electronic W & M seal
•
Corrections to the recording of low flow rates and the presentation of
volume to several decimal places
•
Adaptation of the pre-sets for product densities in accordance with
PTB Memo 109, 5/99
14.9.3
Version 3.00
•
Remote control of the discharge (start/stop, volume/flow display) via
RF
•
Limit monitoring indicator via RF
•
Dead man’s switch via RF
•
Interface to on-board computers from third-party manufacturers (via
ancillary equipment)
14.9.4
Version 3.04
•
Evaluation of pulse errors depending on the actual flow rate
14.9.5
Version 3.10
•
Support of EPSON-FX compatible printer
•
Operator advice for product changes
•
Free assignment of hose sets to the individual products
To Next Page