•
Broadcast OPEN in standalone mode if MultiFlow is the printer
administrator
•
Adjustable protection level for density input
•
Revision of time synchronization with EMIS
•
Modified vowels ('umlauts') reintroduced in German (DE) version
•
Optimization of MFIO2 activation
•
Setting of currency symbol via EMIS
•
Reaction to short-term non-availability of EMIS implemented
•
Partially present delivery note/invoice query removed from OBC
orders
•
Activation of sensor monitoring is no longer subject to supervisor ID
code
•
Supplement and modification of residue removal wait display.
Adjustment of status details and installation of a filling request function
and a direct link to the residue removal menu
•
Fill level monitoring via EPE2 and evaluation of measuring system
problems when dispensing operation is suspended (interrupted)
•
Support of EPE2-A1 added to residue removal control function
•
Separate logbook and parameter reset
•
Possible query for residue removal after every change of product
•
Software adjustment due to modified hardware components
•
New assignable elements available, extracted from sum totals block
•
Adjustments for operation with the MultiControl2 (MC2)
•
Printing via CAN bus
14.9.23
Version 5.08 (MID)
•
Modification of logbook access on detection of existing emergency
acknowledgments
14.9.24
Version 5.09 (MID)
•
Expansion of residue removal control (menu 8) when using an EPE-AI
14.9.25
Version 5.10 (MID)
•
Extended assignment layout for OBC operation
•
Idle speed measurement
14.9.26
Version 5.11 (MID)
•
AS Status Info
•
Turbine and Multi-IO support disabled
To Next Page