•
Error message on printer in the case of defective display
communication
•
Rectification of problem within the booter housing
•
(De)activation of automatic sending of delivery data to the EMIS
•
Extended copy control
•
Discharge delay
14.9.20
Version 5.05 (MID)
•
Modification of status information for 'Residue removal from EPE2“
(Menu 8) and status monitoring of the EPE2
•
Remedying of problems: output modification in OBD mode
•
Revision of status detection of measuring system while output is
suspended
14.9.21
Version 5.06 (MID)
•
New parameter 3.1.6.8.4 for EPE2 signal inversion
14.9.22
Version 5.07 (MID)
•
Checking of sequence of receipt numbers before start of print run
•
Problem with scanning of parameters from version 5.00 via chip card
remedied
•
New product groups RME and SME
•
Taking account of start and end time on unmeasured outputs
•
Start of a test stroke of the additive pump possible via diagnosis menu
4.3.1. During the test stroke a display shows details of the number of
strokes completed and the total volume of additive dispensed.
•
Transmission of sensor logbook data for the EMIS
•
Extension of the order number field and input of a standard specified
value is possible. In addition, the security class (supervisor or driver)
can be adapted to provide access to the standard specified value.
•
Printing via the CAN bus implemented
•
Activation of the MFIO2 to monitor the two interface inputs possible
even when links are disabled and without additional hose routings.
Detected status changes are, if present, saved with their
corresponding GPS coordinates in the logbook.
•
Problem with reception of dispensing order from EMIS with activated
electronic seal remedied
•
Problem with second discharge stop and use of two wet hoses
remedied
To Next Page
Loading...
