•
Separate delivery note and invoice numbers: The newly introduced
parameter 3.1.9.1 enables the use of different receipt numbers for
delivery notes and invoices. These can be pre-set under 3.1.9.2 – 4. If
two numbering cycles are used, the invoice and delivery note
numbers are respectively prefixed by different identifiers (e.g. Invoice:
R012345, Delivery note L012345). If the separate numbering cycles
are activated it is not possible for the MultiFlow to produce an invoice
for a receipt originally printed as a delivery note.
•
The number of data bits can be specified irrespective of the parity
setting. The following combinations are supported: 8N1, 8E1, 8O1,
7N2, 7E1 and 7O1.
14.9.19
Version 5.01 (MID)
•
Revision of the output of the cumulative statuses on the receipt
•
Specification of the minimum Belgian receipt layout changed
•
Revision of date setting
•
Data bit changes can also be adopted without restart
•
Revision of printer allocation in the case of multiple measuring
systems with TM-U295
•
Stop delivery if temperature falls below the minimum threshold
•
Optional additional details of comp. weight in product block
•
Modification of compartment flushing
•
EPSON TM-U295 defined as default printer with 8E1 format
•
Receipt elements "Compartment number", "Delivery pre-set" and
"Order number" added
•
Support of the EMIS
•
Support of ethanol mixes
•
Error message on printer in the case of defective display
communication
•
IO test extended in the service menu
•
IO status display during delivery
•
Maximum additive mixing ratio increased
•
Support for the external IO interface incl. user-specific links and
additional hose paths
•
Support of the external sensor interface including user-specific
configuration, alarm messages and sensor monitoring
•
Cyrillic characters can be selected using: "+/-" and "0"
•
Pre-set modification enable/disable
•
Configurable automatic sending of delivery data to the EMIS
•
Minimum waiting time for OBC connection via CAN bus
To Next Page