•
Activation of sensor monitoring no longer subject to supervisor
password
•
Software revision due to updated hardware components
•
Revisions for the operation with MultiControl2 (MC2)
•
Optional residue removal query after every product change
•
New receipt elements extracted from the sum block available
14.9.16
Version 3.60
•
Extended assignment layout for OBC operation
•
AS Status Info
•
Turbine and Multi-IO support disabled
•
The previous form of temperature compensation for mixed products
such as E10 is being replaced by the re-evaluation process currently
specified.
•
Logbook handling revised
14.9.17
Version 3.61
•
Transmission of logbook data for EMIS
•
Query for MFSI configuration via EMIS
14.9.18
Version 5.00 (MID)
•
Separation of calibration-relevant and non calibration-relevant
program sections
•
Introduction of download logbook (Audit-Trail)
•
Introduction of scale prices
•
Summary of orders transferred by the OBC
•
Option of residue discharge via EPE2
•
Printer selection no longer completely under seal protection. Only the
"No printer" option requires the electronic seal to be broken.
•
New CEF telegram (TMC protocol) included for transfer of additional
product information to the OBC after delivery
•
Optional request for "Receipt copy": When the request is active, user
is asked after each receipt printout whether another copy is required
•
Flushing volume: The parameter 3.1.5.8 has been extended. The
previous parameter for the minimum flushing volume has been
changed from 3.1.5.8 to 3.1.5.8.3. Further additions are 3.1.5.8.1 now
offering a choice of flushing products from the product list,
specification of the standard flushing volume under 3.1.5.8.2 and
activation of a special flushing monitor in OBC mode under 3.1.5.8.4.
To Next Page
Loading...
