TechnipFMC Sening MultiFlow - Page 266

270
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Miscellaneous Information
• IO status display during delivery
• Maximum additive mixing ratio increased
• Support for the external IO interface incl. user-specific links and
additional hose paths
• Support of the external sensor interface including user-specific
configuration, alarm messages and sensor monitoring
• Cyrillic characters can be selected using: "+/-" and "0"
• Pre-set modification enable/disable
• Configurable automatic sending of delivery data to the EMIS
• Minimum waiting time for OBC connection via CAN bus
• Error message on printer in the case of defective display
communication
• (De)activation of automatic sending of delivery data to the EMIS
14.9.15 Version 3.59
• Check document numbering sequence before start of print-out
• New product groups RME and SME
• Take into account start and end time for unmeasured discharges
• Start of a trial lift for the additive pump possible via diagnostic menu
4.3.1. During the trial lift, details of the number of lifts to be run
through and total quantity of additive discharged are displayed.
• Transfer sensor logbook data to EMIS
• Possible to extend order number field and input a standard value. In
addition the protection class (supervisor or driver) for access to the
standard value can be revised.
• Printing is possible via the CAN-Bus
• Control of the MFIO2 to monitor both interface inputs is also possible
with deactivated connections and without additional hose routes.
Detected changes to condition, if these have occurred, will be stored
with the corresponding GPS co-ordinates in the log book.
• Problem with receipt of discharge orders from EMIS when electronic
seal is set resolved.
• Problem with second discharge stop and use of 2 full hoses resolved.
• Adjustable protection level for density input
• Revision of time synchronization with EMIS
• Umlauts reintroduced in German version
• Optimization of MFIO2 control
• Set currency symbol via EMIS
• Reaction to short-term non-achievability of EMIS implemented
• Partially available delivery note/invoice query for OBC orders removed