•
Flushing volume: Parameter 3.1.5.8 has been extended. The previous
parameter for the minimum flushing volume has been changed from
3.1.5.8 to 3.1.5.8.3. Further additions are: 3.1.5.8.1 now offering a
choice of flushing products from the product list, specification of the
standard flushing volume under 3.1.5.8.2 and activation of a special
flushing monitor in OBC mode under 3.1.5.8.4.
•
Separate delivery note and invoice numbers: The newly introduced
parameter 3.1.9.1 enables the use of different receipt numbers for
delivery notes and invoices. These can be pre-set under 3.1.9.2 – 4. If
two numbering cycles are used, the invoice and delivery note
numbers are respectively prefixed by different identifiers (e.g. Invoice:
R012345, Delivery note L012345). If the separate numbering cycles
are activated it is not possible for the MultiFlow to produce an invoice
for a receipt originally printed as a delivery note.
14.9.12
Version 3.49
•
The number of data bits can be specified irrespective of the parity
setting. The following combinations are supported: 8N1, 8E1, 8O1,
7N2, 7E1 and 7O1.
14.9.13
Version 3.50
•
Revision of the output of the cumulative statuses on the receipt
•
Specification of the minimum Belgian receipt layout changed
•
Revision of date setting
•
Data bit changes can also be adopted without restart
•
Modification of the "Blow down" function in the UK variant
•
Revision of printer allocation in the case of multiple measuring
systems with TM-U295
•
Stop delivery if temperature falls below the minimum threshold
•
Optional additional details of comp. weight in product block
•
MultiFlow->EMIS data transfer
14.9.14
Version 3.54
•
EPSON TM-U295 defined as default printer with 8E1 format
•
Receipt elements "Compartment number", "Delivery pre-set" and
"Order number" added
•
Support of the EMIS
•
Support of ethanol mixes
•
Error message on printer in the case of defective display
communication
•
IO test extended in the service menu
To Next Page