•
Printout of V0 / VT on the delivery receipt can take place in a product-
dependent manner
14.9.10
Version 3.45
•
Transfer of the totalizer data to the EMIS interface
•
Default value of pulse type changed from PNP to THS
•
Printer driver: No subscripts possible
•
New parameter: 3.1.4.4.1 (Default delivery pre-set)
•
The sensor type (menu 3314) is reset to the default type (THS type)
after a factory reset
•
Request for totalizer data via EMIS is also possible during an ongoing
delivery. After an unplanned delivery the MultiFlow transfers the actual
delivery data to the EMIS.
•
Printer management revised for use of two MultiFlows and
simultaneous actuation of the Print key
•
VAT is calculated even if the cumulative block is printed out before the
product block
•
Detection of defective reference meters
•
If you press STOP to exit a menu selected with ENTER or START you
do not return to the main menu or to the last menu selected with a
number. You go back only to the previous menu
•
Time can only be changed after password request
•
Detection of RTC readout error
•
If a product is selected whose price factor has been set to 0 (fixed
price) there is no need to enter a delivery quantity in the input window
•
If the print receipt includes details of the meter status before the start
of the delivery, the correspondingly relevant unit for the delivered
product is taken into account now.
•
Control of EPSON TM-U295
•
No double product entry in the logbook after cancelled delivery
14.9.11
Version 3.48
•
Introduction of scale prices
•
Summary of orders transferred by the OBC
•
Printer selection no longer completely under seal protection. Only the
"No printer" option requires the electronic seal to be broken
•
New CEF telegram (TMC protocol) included for transfer of additional
product information to the OBC after delivery
•
Optional request for "Receipt copy": When the request is active, user
is asked after each receipt printout whether another copy is required.
To Next Page