TechnipFMC Sening MultiFlow - Page 275

Sening
®
is a registered trademark of FMC Technologies
279
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Software update
 Put laptop and Sening components into operation.
 Start the download software (UDO.EXE) on the laptop. This program is
available upon request from our Service department. If software program
is not yet installed, install same from the software disk.
 Choose the command ‘Verbinden‘ in the ‘Verbindung‘ menu.