☺ Then the next product (if registered) is displayed for confirmation. After
confirming the last product and pressing the <Print> key an invoice is
printed out.
According to the settings of
Parameter 3.1.4.5.6, after the
invoice has been printed a
query about the customer’s
mode of payment is displayed.
After printing the note and
entering the payment mode the
MultiFlow is ready for the next
discharge.
All delivery data as well as the
payment mode is entered to
the logbook.
☺ Now the discharge is completed.
Depending on the setting of Parameter 3.1.4.2, the display of the latest
amount or product delivered is turned off immediately or after a pre-
selected number of minutes. At factory this parameter is set to a default
of 15 min. When this time has elapsed the Start screen is displayed once
more.
6.6.1
Using the Printer
As standard the MultiFlow comes equipped with the printer DR-295 or
DR-298 FDW respectively, whose operating instructions are described
in the following. If a different printer is used, please use the respective
operating manual.
Turn on the printer using the power switch on its left side.
Only the latest printer models have this switch.
☺ The printer is ready for printing when the POWER light is on.
Paper can be inserted only when both the POWER OUT and RELEASE
lights are on.
•
The PAPER OUT light is on when no paper is inserted in the printing
section of the print head.
•
The RELEASE light on indicates that the print head is lifted and the
printer is in the paper release mode.
Press the RELEASE button to lift the print head.
To Next Page
Loading...
