If you do not want the two
devices to synchronize, this
can be deactivated with
parameter 3.1.4.5.8.2.
MultiFlow displays a special
status screen during this period
to inform the user about the
current transfer status of the
EMIS. This provides
information about transfer
problems and alerts to the end
of the transfer. The display of
this status screen can be deactivated via parameter 3.1.4.5.8.1. In this
case information about the transfer status is output only as a system
message in the start screen of the MultiFlow.
The current delivery data is
transmitted to the EMIS directly
after completion of the delivery.
The transmission of event data
and the trip report can be
initiated with menu item 7.2 in
the print menu.
If you do not want the delivery data to be transmitted automatically to
the EMIS directly after the delivery, activate the parameter "Disable
AutoTx” (menu 3.1.6.3.2).
If synchronization between EMIS and MultiFlow is not possible, the wait
screen can be cancelled manually at the earliest after 90sec with the
START, STOP or ENTER keys to enable a delivery to be initiated
(without office connection via EMIS).
If you do not want the two devices to synchronize, this can be
deactivated with parameter 3.1.4.5.8.2.
To Next Page
Loading...
