Setup Information
110
Confirm Password Field
The Confirm Password field is used to confirm the password you entered in the New Password field.
This password must match the password entered in the New Password field.
Edit Button
The Edit button is used to make changes to the User system account password. The edit button is inactive until the user
account is enabled.
NOTE: The admin account can not be modified.
To enable the user account, do the following:
1. Select the Enable check box next to the account,
2. Click Submit.
The edit button becomes active.
NOTE: The only configurable fields are the New Password field and the Confirm Password field. Also, when the
Edit window is open, a Set No Password check box appears. For more information, see “Edit User Accounts
Window” on page 114.
Save Button
The Save button is used to temporarily save changes to the system account.
NOTE: Click Submit to save the change to the console.
Submit Button
The Submit button, located at the bottom of each configuration window, is used to upload changes to the IP-223. Clicking
Submit saves changes in temporary memory only.
To permanently save changes, do the following:
1. Click Submit.
The changes are sent to the IP-223 in temporary storage.
2. Click Save to EEPROM.
The Save to EEPROM window opens.
3. Click Save Parameters.
Changes are now permanently saved to the IP-223 console
To Next Page
Loading...