Telex IP-223 - System Parameters; Resetting System Parameters

Setup Information
112
Reset System Parameters Button
The Reset System Parameters button resets all parameters, except multicast and port numbers, in the IP-223 to the factory
defaults.
To reset the system parameters, do the following:
1. Select the Reset System Parameters radio button.
2. In the reset confirmation code number field, enter the reset confirmation code number.
3. Click Reset.
4. Click Save to EEPROM.
5. Click Save Parameters.
System settings on both the console and browser configuration windows are reset.
OR
Click Reset IP-223, to undo and restore system parameters to the last saved configuration.
System settings on both the console and the browser configuration windows are set to the previously saved version.
Restore Factory Defaults Radio Button
The Restore Factory Defaults radio button is used to restore the configuration webpages to the factory default settings. All
previously entered settings are deleted from all browser configuration windows.
The console settings are not restored until the Reset button is clicked and the changes are saved to EEPROM.
NOTE: The parameters can be restored if the settings have not been saved to the console with the Save Parameters
button. An undo is accomplished by clicking Reset.
To restore the factory defaults, do the following:
1. Select the Restore Factory Defaults radio button.
2. In the reset confirmation code number, enter the reset confirmation code number.
3. Click Reset.
Parameters are reset or factory defaults restored, depending on selection.
4. Click Save to EEPROM.
5. Click Save Parameters.
Factory default settings are restored to the browser configuration windows.
OR
Click Reset IP-223, to undo and restore system parameters to the last saved.
System settings on both the console and the browser configuration windows are set to the previously saved version.
Reset Confirmation Code Number
The Reset Confirmation Code Number indicates permission to reset system parameters is granted.
Enter Reset Confirmation Code Field
The Enter Reset Confirmation Code field is used to enter the reset confirmation code number. Once the code is entered, the
software recognizes the user is authorized to make the change.
The Reset Confirmation Code Number is generated by the firmware and appears in the window.
System Parameters