Setup Information
126
Enable Line-Line Check Box
The Enable Line-Line check box indicates audio can be crosspatched from one line to another line. TX traffic from the
console overrides the crosspatch to allow the console operator to take control of the line.
Start Patch FTone Drop Down Menu
NOTE: When using the Start and Stop FTone, the Line-Line check box must NOT be selected.
The Start Patch FTone drop down menu identifies the Ethernet function tone selection that starts a crosspatch between line 1
and line 2.
Stop Patch FTone Drop Down Menu
The Stop Patch FTone drop down menu identifies Ethernet function tone selection that stops a crosspatch between line 1 and
line 2.
Enet Patch Timeout Field
The Enet Patch Timeout field is used to switch a full-duplex IP-223 line to a half-duplex line when an Ethernet crosspatch is
active. When the Enet Patch Timeout expires, the IP-223 line switches back to full-duplex regardless the Ethernet crosspatch
state.
The range for this field is 0 to 3600 secs.
Default is 0 (disabled).
Enable RCP Check Box
The Enable RCP check box indicates RCP (Remote Crosspatch) is enabled. If selected, RCP is enabled.
Dialing Digits Field
The Dialing Digits field identifies the number of DTMF (Dual Tone Multi-Frequency) digits allowed in the Drop All, Add
String, and Delete String fields on the window.
The range for this field is 2 to 4.
Interdigit Time Field
The Interdigit Time field identifies the amount of time, in ms, allowed between DTMF digits before a reset occurs. If a reset
occurs, the DTMF sequence must be started again.
This range for this field is 0 to 32000ms
Local Setup
Network Setup
Remote Setup
To Next Page
Loading...