Setup Information
38
Using HyperTerminal
HyperTerminal is an alternate method to set the IP Address and Subnet Mask using Microsoft HyperTerminal.
NOTE: J35 must be in the A position.
To assign the IP Address and Network Mask using HyperTerminal, do the following:
1. Using a DB-9 serial cable, connect the IP-223 to your PC.
2. From the Start menu, select Programs.
The Programs flyout menu appears.
3. Select Accessories.
The Accessories flyout menu appears.
4. Select Communications.
The Communications flyout menu appears.
5. Select HyperTerminal.
The HyperTerminal and Connection Description windows open, see Figure 10.
OR
If the HyperTerminal window opens, if a connection to HyperTerminal is already configured.
6. From the Connection window, enter com in the Name field.
OR
If the HyperTerminal window opens, proceed to step 13.
7. Click OK.
The Connect To window appears.
8. From the Connect Using drop down menu, select COM1.
9. Click OK.
The Com1 Properties window appears.
10. From the Bits per second drop down menu, select 19200.
FIGURE 9. HyperTerminal Navigation
To Next Page
Loading...