Telex IP-223 - Line Button; TX LED; LNK LED

19
Front Panel
To toggle the LCD display, do the following:
1. Press and hold the line button and then momentarily press the IC button.
Three (3) different displays are available with each press of the IC button:
• While pressing the line button, press the IC button once.
The IP Address and Mask Address of the unit displays.
• Continue to hold the line button, then press the IC button a second time.
The TX alignment tones are turned ON.
• Continue to hold the line button, then press the IC button a third time.
The RX VU meter displays.
2. Press the IC button a fourth time to clear the display.
The LCD display returns to the normal.
3. Release the line button.
Line Button
The Line button is used to select which radio, or line, the handset audio is routed to and which line is being monitored. The
handset line selection is displayed as an asterisk (*) in the right most column of the LCD display. An asterisk (*) on the top
line of the display indicates a connection to line 1, and an asterisk (*) on the bottom line of the display indicates a connection
to line 2.
TX LED
The TX LED provides a visual indication the IP-223 is generating IP packets. When the LED is illuminated, packets are being
transmitted to the network.
LNK LED
The LNK LED provides a visual indication of the Ethernet connection. When the LED is illuminated, a valid network
connection is established.