Setup Information
136
Next 30 Entries Button
The Next 30 Entries button is used to traverse the window between crosspatch PIN entries 1 and 300.
To define crosspatch PIN numbers, do the following:
1. Click CRP PIN Table.
The Remote CrossPatch Pin Setup window appears.
2. Select the PIN Enable check box if a PIN number is required to create a crosspatch.
3. In the PIN field, enter a PIN number for the crosspatch number.
4. Continue entering a 4-digit PIN number for the crosspatch numbers until all required PIN entries are complete on
the window.
5. If all of the PIN entries are complete on the window and more PINs need to be defined, click Submit.
The entries currently displayed on the window are sent to the IP-223 for storage.
OR
If all required Crosspatch PIN entries are complete on the window and no more PINs need to be defined, click
Submit and proceed to step 9.
The entries currently displayed on the window are sent to the IP-223 for storage.
6. Click Next 30, to move to the next Remote CrossPatch Pin Setup window.
7. Repeat the steps 3 through 5 above to continue entering the Crosspatch PIN entries until all of the required PIN
entries have been completed.
8. After all PINs have been entered, click Submit.
The entries currently displayed on the window are sent to the IP-223 for storage.
9. Click Save to EEPROM.
The Save Setup Parameters window appears.
10. Click Save Parameters.
The entries are saved to permanent memory.
To Next Page
Loading...