Telex IP-223 - Password Management and No Password Option

115
Edit User Accounts Window
NOTE: The information is not stored in permanent memory until it is saved, as explained in “Save Parameters Button”
on page 106.
To change the admin System Account Password, do the following:
1. In the Current Password field, enter the current password.
OR
Leave blank if no password is required.
2. In the New Password field, enter a new password.
Asterisks appear for each character.
3. In the Confirm Password field, enter the password again.
Asterisks appear for each character.
4. Click Save.
5. Click Save to EEPROM.
The Save to EEPROM window appears.
6. Click Save Parameters to save the changes to the IP-223.
To change the system account password from an actual password to no password, do the following:
1. Leave the New Password and Confirm password fields blank.
2. Click Save.
3. Click Save to EEPROM.
The Save to EEPROM window appears.
4. Click Save Parameters to save the changes to the IP-223
To change the user system account password or edit the account, do the following:
1. Select the Enable check box next to the user username.
2. Click Submit.
Once enabled, the New Password, Confirm Password fields, Edit and Save buttons become active.
3. In the New Password field, enter a new password.
The password can be 4-16 alpha-numeric characters in length.
4. In the Confirm Password field, enter the password again.
5. Click Save.
6. Click Save to EEPROM.
The Save to EEPROM window appears.
7. Click Save Parameters to save the changes to the IP-223.
Set No Password Check Box
The Set No Password check box is used to indicate the account does not require a password.
To set no password for the system user account, do the following:
1. Under the New Password column, select the Set No Password check box.
2. Click Save, to save changes and return to the Account Setup window.
OR
Click Cancel, to discard changes and return to the Account Setup window.