Tescom TC-3000C - Settings for RS-232 C(Host Controller) Remote Control Using DLL; Settings for the RS-232 C(Host) Remote Control Without Using DLL

5.2 Getting Started
100
(1) write_tester_hci_tl(1); // 1:USB
(2) write_tester_hc_port(0); // 0:USB1
5.2.3 Settings for RS-232C(Host Controller) remote control using DLL
1. The supplied RS-232C cable is used to connect RS-232C port of TC-3000C Host
Controller with serial port of user PC.
2. Turn on TC-3000C.
3. Call the following functions in your application to make RS-232C remote control program
using DLL.
(1) write_tester_hci_tl(2); // 2: RS-232C
(2) write_tester_hc_port(0); // 0 : COM1
5.2.4 Settings for the RS-232C(Host) remote control without using DLL
1. Setting up RS-232C Parameters: Press Menu  Select “Configuration” from the pop-
up menu on the screen  M5 (Network)  F8 (More 1/3)  Setting up RS-232C
Parameters.
2. You can ascertain whether your RS-232C settings including cable connection state is
correct through Hyper Terminal on your PC.
3. If your RS-232C settings are right, the screen of TC-3000C will be changed as follows.
FAILED to autodetect connection to DSP
Your choice :
- check cable, and click Retry,
- or, click Quit to shutdown
Retry
Quit
X
READ:SERIAL_NUM?
3000C2A0023
EXEC:RESET
OK
Log hide
Local
PgUp
PgDn
Home
End
Change remote mode to local mode
Hide all commands and responses