3.5 Operation Procedure (Measurement/Measurement2)
49
3.5 Operation Procedure (Measurement/Measurement2)
This chapter describes the operation procedure of RF Measurement.
When you select the measurement screen or run the test cases, the TC-3000C makes a
connection to DUT that is discovered firstly and begins to test automatically although there
are several BT devices nearby. If you want to test a specific device in several devices, go
through the step 2 in the Link Analyzer screen or Host Analyzer screen in advance.
If there is a connection with DUT already, the TC-3000C begins the test immediately
without the connection procedure.
3.5.1 Step 3. Selecting the Measurement Screen
Measurement can be accessed by pressing the Menu hard key. Press Menu
Rotary Knob or Select “Measurement” from the pop-up menu on the screen
ENT
When you select the measurement screen, the TC-3000C makes a connection to DUT that
is discovered firstly and begins to measure RF signals automatically.
3.2 “Basic Operation Procedure” should be performed before following steps.
To Next Page
Loading...