Tescom TC-3000C - Operation Procedure (EDR Measurement); Step 3. Selecting the EDR Measurement Screen

3.6 Operation Procedure (EDR Measurement)
57
3.6 Operation Procedure (EDR Measurement)
This chapter describes the operation procedure of EDR Measurement.
When you select the EDR measurement screen or run the test cases, the TC-3000C
makes a connection to DUT that is discovered firstly and begins to test automatically
although there are several BT devices nearby. If you want to test a specific device in
several devices, go through the step 2 in the Link Analyzer screen or Host Analyzer screen
in advance.
If there is a connection with DUT already, the TC-3000C begins the test immediately
without preceding connection procedure.
3.6.1 Step 3. Selecting the EDR Measurement Screen
EDR Measurement can be accessed by pressing the Menu hard key. Press Menu
 Rotary Knob or    Select “EDR Measurement” from the pop-up menu on the
screen  ENT
When you select the measurement screen, the TC-3000C makes a connection to DUT that
is discovered firstly and begins to measure RF signals automatically.
NOTE
“Basic Operation Procedure” on page 3-12 should be performed before following
steps.