Tescom TC-3000C - Audio Test Command

5.3 Reference Guide using RS-232C commands
142
CONF:RFTC:EML:BYTES <Value>
Description
This command sets number of received byte for EDR Maximum Input Level(RCV/CA/10/C) measurement.
Value
Number of samples : 0 ~ 2147000000, 200000(default)
READ:RFTC:EML:BER?
Description
This command reads BER value for EDR Maximum Input Level(RCV/CA/10/C) measurement. Before
reading this value use “READ:RFTC:EML:BER?” Command, RF test case should be executed to update this
value by sending “EXEC:RFTC:EML:RUN ”.
5.3.26 Audio Test Command
EXEC:AUDIO:CONN
Description
This command executes ACL connection with profile.
EXEC:AUDIO:DISC
Description
This command executes disconnection after closing profile.
EXEC:AUDIO:TONE_INIT
Description
This command executes tone initialization before tone generation.
EXEC:AUDIO:TONE_START
Description
This command starts sending of audio tone signal to the DUT.
EXEC:AUDIO:TONE_STOP
Description
This command stops sending of audio tone signal to the DUT.
EXEC:AUDIO:INCOMING_CALL
Description
Tester shall send a sequence of unsolicited RING alerts to the HF(DUT). The HF shall produce a local
alerting in reaction to the RING.
Response
<Incoming_call> : OK | Disconnected Profile State | unknown command error
READ:AUDIO:PROFILE_TYPE?
Description
This command reads the type of the DUT profile.
CONF:AUDIO:PROFILE_TYPE
Description
This command writes the type of the DUT profile.
Value
profile type : NONE, HEADSET, HANDSFREE(default), AUDIOGATEWAY