Tescom TC-3000C - Page 143

5.3 Reference Guide using RS-232C commands
143
READ:AUDIO:TONE_FREQ?
Description
This command reads the frequency of the tone signal which would be sent by a tester.
CONF:AUDIO:TONE_FREQ
Description
This command writes the frequency of the tone signal which would be sent by a tester.
Value
tone frequency : 400 ~ 1000, 1000(default)
READ:AUDIO:TONE_LEV?
Description
This command reads the amplitude of the tone signal which would be sent by a tester.
CONF:AUDIO:TONE_LEV <Value>
Description
This command writes the amplitude of the tone signal which would be sent by a tester.
Value
tone frequency : -70 ~ 3, -10(default)
READ:AUDIO:TEST:AUDIO_IN?
Description
This command reads notch filter value.
CONF:AUDIO:TEST:AUDIO_IN <Value>
Description
This command writes notch filter value in accordance with received audio signal.
Value
notch filter : 400, 1000(default)
READ:AUDIO:GAIN_CTRL?
Description
This command reads the parameter which decides whether it controls a mike or speaker gain during
connection procedure with Profiles.
CONF:AUDIO:GAIN_CTRL <Value>
Description
This command sets the parameter which decides whether it controls a mike or speaker gain during
connection procedure with Profiles.
Value
Gain Control : ON, OFF(default)
READ:AUDIO:VGS?
Description
This command reads speaker gain during connection procedure with Profiles.
CONF:AUDIO:VGS <Value>
Description
This command sets speaker gain during connection procedure with Profiles.
Value
VGS : 0~15, 15(default)