Tescom TC-3000C - Preparing for Your Application Using DLL; Reference Guide Using RS-232 C Commands; Configuration Command

5.3 Reference Guide using RS-232C commands
101
5.2.5 Preparing for your application using DLL
1. Insert library Disk in a floppy disk drive of Remote Control Computer.
2. Copy following files to your application directory from the library Disk.
tc3k.dll, tc3k.lib, tester_dll.h, platform.h
5.3 Reference Guide using RS-232C commands
5.3.1 Configuration Command
READ:SYS:TESTER:HCI_TO?
Description
This command reads the timeout of HCI commands execution in miliseconds.
CONF:SYS:TESTER:HCI_TO <Value>
Description
This command set the timeout of HCI commands execution in miliseconds.
Value
HCI Timeout : 1 ~ 65535, 2000(default)
READ:SYS:TESTER:L2CAP_TO?
Description
This command reads the timeout of L2CAP commands execution in milliseconds.
CONF:SYS:TESTER:L2CAP_TO <Value>
Description
This command set the timeout of L2CAP commands execution in milliseconds.
Value
L2CAP Timeout : 1 ~ 65535, 5000(default)
READ:SYS:TESTER:RFCOMM_TO?
Description
This command reads the timeout of RFCOMM commands execution in milliseconds.
CONF:SYS:TESTER:RFCOMM_TO <Value>
Description
NOTE
You must use the library files correspond to TC-3000C version. When TC-3000C is
upgraded the library files should be changed with the new version files. You can
download the library files from Tescom website(www.tescom.co.kr).
NOTE
If you set this to improper value so as to reduce timeout, you may have a trouble
measuring. Accordingly, be careful of a change of this value.