Tescom TC-3000C - 20 Db Bandwidth(20 BW)

5.3 Reference Guide using RS-232C commands
116
5.3.9 20dB Bandwidth(20BW)
EXEC:RFTC:20BW:RUN
Description
This command executes the measurement of the lowest and highest frequencies below and above the
operating frequency at which transmit power drops 20dB below the highest power value in the transmit
channel at the given TX frequency. This can be used for TX Output Spectrum -20dB Bandwidth test
case(TRM/Ca/05/C).
EXEC:RFTC:20BW:STOP
Description
This command stops execution of measurement of 20 dB bandwidth.
READ:RFTC:20BW:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:20BW:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:20BW:DATA_LEN?
Description
This command reads length of payload’s data.
CONF:RFTC:20BW:DATA_LEN <Value>
Description
This command writes length of payload’s data.
Value
length of payload’s data : 0 ~ 339, 1(default)
READ:RFTC:20BW:SWP_NUM?
Description
This command reads number of sweeps.
CONF:RFTC:20BW:SWP_NUM <Value>
Description
This command writes number of sweeps.
Value
Number of sweeps : 1 ~ 65535, 1(default)
READ:RFTC:20BW:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:20BW:TEST_MODE <Value>
Description
This command writes test mode.