Tescom TC-3000C - Modulation Characteristics(MOD)

5.3 Reference Guide using RS-232C commands
118
Description
This command reads test mode.
CONF:RFTC:ACP:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST(default), NULL_PKT_TEST
READ:RFTC:ACP:P_TX?
Description
This command reads power in adjacent channel.
5.3.11 Modulation Characteristics(MOD)
EXEC:RFTC:MOD:RUN
Description
This command executes measurement of the modulation index for 11110000 and 10101010 bit patterns at
the given TX frequency. This can be used for the Modulation Characteristics test case(TRM/CA/07/C).
EXEC:RFTC:MOD:STOP
Description
This command stops execution of modulation characteristics.
READ:RFTC:MOD:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:MOD:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:MOD:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:MOD:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : LONGEST(default), DM1, DH1, AUX1, DM3, DH3, DM5, DH5
READ:RFTC:MOD:PACK_NUM?
Description
This command reads number of packets.
CONF:RFTC:MOD:PACK_NUM <Value>
Description
This command writes number of packets.