5.3 Reference Guide using RS-232C commands
111
This command writes number of packets.
Value
number of packet : 1(default), 0 ~ 65535
READ:RFTC:OP:HOP?
Description
This command reads hopping mode.
CONF:RFTC:OP:HOP <Value>
Description
This command writes hopping mode.
Value
hopping mode : ON(default), OFF
READ:RFTC:OP:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:OP:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST, NULL_PKT_TEST
READ:RFTC:OP:P_AVG?
Description
This command reads the average power.
READ:RFTC:OP:P_MIN?
Description
This command reads minimum power.
READ:RFTC:OP:P_MAX?
Description
This command writes maximum power.
5.3.5 Power Density(PD)
EXEC:RFTC:PD:RUN
Description
This command executes measurement of the lowest and highest frequencies below and above the operating
frequencies at which spectral power density drops below the level of 80dBm/Hz e.i.r.p(-30dBm if measured
in a 100kHz bandwidth). This can be used for the power density test case(TRM/CA/02/C).
EXEC:RFTC:PD:STOP
Description
This command stops execution of power density measurement.
READ:RFTC:PD:DATA_LEN?
Description
This command reads length of payload’s data.
To Next Page
Loading...
