Tescom TC-3000C - Initial Carrier Frequency Tolerance(ICFT)

5.3 Reference Guide using RS-232C commands
119
Value
number of packet : 10(default), 0 ~ 65535
READ:RFTC:MOD:HOP?
Description
This command reads hopping mode.
CONF:RFTC:MOD:HOP <Value>
Description
This command writes hopping mode.
Value
hopping mode : ON(default), OFF
READ:RFTC:MOD:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:MOD:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST(default), NULL_PKT_TEST
READ:RFTC:MOD:DF1_AVG?
Description
This command reads average of all maximum frequency deviations from the average frequency for the
11110000 pattern in HZ divided by 100.
READ:RFTC:MOD:DF2_AVG?
Description
This command reads average of all maximum frequency deviations from the average frequency for the
10101010 pattern in Hz divided by 100.
READ:RFTC:MOD:DF2_MIN?
Description
This command reads minimum of all maximum frequency deviations from the average frequency for the
10101010 pattern in Hz divided by 100.
READ:RFTC:MOD:DF2_RATE?
Description
This command reads pass rate of all maximum frequency deviations from the average frequency for the
10101010 pattern in Hz divided by 100.
5.3.12 Initial Carrier Frequency Tolerance(ICFT)
EXEC:RFTC:ICFT:RUN
Description
This command executes measurement of the transmitter carrier frequency accuracy at the given TX
frequency. This can be used for the initial carrier frequency tolerance test case(TRM/CA/08/C).
EXEC:RFTC:ICFT:STOP
Description
This command stops execution of initial carrier frequency tolerance.