Tescom TC-3000C - RF Test Cases Command; Output Power(OP)

5.3 Reference Guide using RS-232C commands
110
This command reads the BD addresses which are discovered during the Discover procedure.
5.3.3 RF Test Cases Command
EXEC:RFTC:STOP
Description
This command stops measurement of test cases in progress.
EXEC:RFTC:CONN
Description
This command executes connection(LMP level).
EXEC:RFTC:DISC
Description
This command executes disconnection if connection exists.
5.3.4 Output Power(OP)
EXEC:RFTC:OP:RUN
Description
This command executes measurement of the maximum peak and average output power(TRM/CA/01/C).
EXEC:RFTC:OP:STOP
Description
This command stops execution of output power measurement.
READ:RFTC:OP:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:OP:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:OP:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:OP:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : LONGEST(default), DM1, DH1, AUX1, DM3, DH3, DM5, DH5
READ:RFTC:OP:PACK_NUM?
Description
This command reads number of packets.
CONF:RFTC:OP:PACK_NUM <Value>
Description