Tescom TC-3000C - Carrier Frequency Drift(CFD)

5.3 Reference Guide using RS-232C commands
121
This command reads average deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
5.3.13 Carrier Frequency Drift(CFD)
EXEC:RFTC:CFD:RUN
Description
This command executes measurement of the transmitter center frequency drift within a packet the given TX
frequency. This can be used for the carrier frequency drift test case(TRM/CA/09/C).
EXEC:RFTC:CFD:STOP
Description
This command stops execution of carrier frequency drift.
READ:RFTC:CFD:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:CFD:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:CFD:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:CFD:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : LONGEST(default), DM1, DH1, AUX1, DM3, DH3, DM5, DH5
READ:RFTC:CFD:PACK_NUM?
Description
This command reads number of packets.
CONF:RFTC:CFD:PACK_NUM <Value>
Description
This command writes number of packets.
Value
number of packet : 10(default), 0 ~ 65535
READ:RFTC:CFD:HOP?
Description
This command reads hopping mode.
CONF:RFTC:CFD:HOP <Value>
Description
This command writes hopping mode.
Value